Re: Fullscreen application Specs

Just an update

The application has been up since yestrday - 24 hours with no problems. From the Log I can see that several have logged in.

A few minutes ago I replaced the edit module with one that has new rules for positiong and cusor placement. Like to hear you responses to what I did.

Tried to keep as close to the suggestions that you guys gave me that I could.
Bang it around and try to find some bugs.

If you run into any problems or kill the machine please E-mail me as I don't check it all tht often. We will have WRITE/(FILE and SAVE) by the end of the  week/or begining of next week

Roc


--- In [email protected], "paoloG" <crc@...> wrote:
>
> 
> 
> 
> 
> 
> --- In [email protected], "Rocky" <rocsystems@> wrote:
> >
> > Fran  ALL
> >  
> > I really do appreciate your testing - > you wrote:
> > 
> > ------>I get a little disoriented with the screen position after these  prefix commands.  I'm not sure what to expect but it is different than Xedit.
> > 
> >    
> > About the screen jumping around  after inserts and deletes and the setting of the CURSOR position I agree with you that it is very messy.
> > I get confused also
> >  
> > I would like someone to define a set of SPECS and I will do it - Not a big  issue and it can be done in a day. Just need to know what we expect the first line to be after an INSERT,  COPY. MOVE and DELETE and the same for MM  CC DD
> >  
> Rocky,
> I won't repeat my compliments for your execellent job;-)
> 
> IMHO after every MM,M,CC,C etc. the *FIRST* line on the screen should remain in its position (As it does in XEDIT;-)
> 
> I looked a little into your 'terminal stuck problem', and after some DIAL into another Virtual Machine and then disconnecting and reconnecting the TN3270 session it appears that VM/370 doesn't detect when a dialed terminal goes off.
> 
> If  you disconnect and reconnect a TN3270 session within your application the screen you were working on is resent without dropping the DIALED GRAF and with a message 'KEY PRESSED INVALID'.
> 
> Regards.
> 
> Paul
>