Re: Sixpack 1.2: how to log in two users?

--- In [email protected], Mike Voss <mike@...> wrote:
>
> Now for an *actual* noob question:
> 
> terminals 0C0-0C2 are defined in hercules, but I can only open a session and connect to CP through 0C0. 0C1 just sits at the Hercules banner.
> 
> I've heard the term directory, how does that interact with or substitute for VM's IOGEN? Where do I find either of these entities? -Or does this have nothing at all to do with that? 
> 
> A two-or-three-sentence primer on VM I/O targeted to an MVSer will probably kickstart me suitably. I know MVS sysgens but this seems to come at me a little bit sideways. I'll wager that at the end of the day it's more familiar than I think. 
> I always secretly wanted to be a DOS/VM guy but none of my employers ever wanted to, er, "re-size" their existing MVS installation. At my very first shop we were bringing the systems in-house from a service bureau, and all the VM manuals had arrived, and I was burning through those when they changed their minds and I had to learn instead to support MVS/SP. Can't complain, it just would have been fun... -and retrospectively, the right call for a company of that size. IBM sales was just too darn good.
>

I've the same issue with C1 terminal; it starts disabled.
So you have to give 'ENA C1' or 'ENA ALL' command from VM OPERATOR console (if you are using HercGui give /ENA C1 on the command line.
Believe it's a sort of bug in SixPack.

Regards

Paul