Re: Sixpack 1.2: how to log in two users?

When VM/370 is IPLed the AUTOLOG1 userid logs on and runs its PROFILE EXEC.  It disables the 3277 at 0C1 for use by an MVS guest, should there be one.  It enables all other 3277s.

So I still don't understand why I can't connect with multiple 3278 mod 4s.

--- In [email protected], "paoloG" <crc@...> wrote:
>
> 
> 
> --- In [email protected], Mike Voss <mike@> wrote:
> >
> > Now for an *actual* noob question:
> > 
> > terminals 0C0-0C2 are defined in hercules, but I can only open a session and connect to CP through 0C0. 0C1 just sits at the Hercules banner.
> > 
> > I've heard the term directory, how does that interact with or substitute for VM's IOGEN? Where do I find either of these entities? -Or does this have nothing at all to do with that? 
> > 
> > A two-or-three-sentence primer on VM I/O targeted to an MVSer will probably kickstart me suitably. I know MVS sysgens but this seems to come at me a little bit sideways. I'll wager that at the end of the day it's more familiar than I think. 
> > I always secretly wanted to be a DOS/VM guy but none of my employers ever wanted to, er, "re-size" their existing MVS installation. At my very first shop we were bringing the systems in-house from a service bureau, and all the VM manuals had arrived, and I was burning through those when they changed their minds and I had to learn instead to support MVS/SP. Can't complain, it just would have been fun... -and retrospectively, the right call for a company of that size. IBM sales was just too darn good.
> >
> 
> I've the same issue with C1 terminal; it starts disabled.
> So you have to give 'ENA C1' or 'ENA ALL' command from VM OPERATOR console (if you are using HercGui give /ENA C1 on the command line.
> Believe it's a sort of bug in SixPack.
> 
> Regards
> 
> Paul
>