Re: IND$FILE Update

--- In [email protected], "Rocky" <rocsystems@...> wrote:
>
> thanks Paolo
>  
> I guuess I was so intent on debugging the Ascii to Ebcidec  translation that
> I forgot to pay attetion to the straight ebcidec
> .
>  
> Is that what you are saying?
>  
> I'll take care of that I - rather quickly I hope if that is the issue
>  
> Roc
>  
> But yes its a big step forward.
> The ascii seems to be working OK
>  
> Have you tested with any other emulators besides wc3270 and VISTA
>  
> Roc
> 

Roc,

your guess is right: I tried an EBCDIC to EBCDIC transfer - without
joy -;-)

I'd like to use other emulators but they're awfully expensive (unless you can find a cheaper way to use them ;-)

I have a few  *VERY* old emulators (IRMA - E78 - MYTE - PC3270) but they need a 3270 PC card connected via coax to a 3274....
 
BFN

Paulo   
> 
> From: [email protected] [mailto:[email protected]] On Behalf Of
> paoloG
> Sent: Monday, September 13, 2010 16:30 
> To: [email protected]
> Subject: [H390-VM] Re: IND$FILE Update
> > 
> Hi Roc,
> 
> here are the results of some tests (with nice Brennan's VISTA):
> 
> 1) Transferred an ASSEMBLER source (ASCII) to GIND: OK.
> 
> 2) Transferred an ASM 386 source to GIND: OK (some mess with TABS..;-)
> 
> 3) Transferred an ASSEMBLER source in EBCDIC to GIND: file transfer OK but I
> couldn't find it in FLIST; after some investigation I found it had
> overwritten the last file transferred; anyhow with unintellegible data. 
> 
> 4) Transferred again the same EBCDIC source: now I could find it but
> unintellegible.
> 
> Transferred again the ASM 386 source: OK (but for TABS).
> 
> By all means great improvement; go ahead Roc!
> 
> Paulo
>