RE: Re: Announcing the VM/370 and VM/380 "SixPack" version 1.2 release candidate 1!

What command did you use to connect..

> -----Original Message-----
> From: [email protected] [mailto:[email protected]] On Behalf
> Of Rocky
> Sent: 15 October 2010 16:49
> To: [email protected]
> Subject: RE: [H390-VM] Re: Announcing the VM/370 and VM/380 "SixPack"
> version 1.2 release candidate 1!
> 
> 
> 
> 
> OK, so can someone say if I did something wrong or is this an issue with
> how
> DMKRIO was produced?
> 
> Blake
> 
> --- In [email protected], "paoloG" <crc@...> wrote:
> > > the Sixpack is defined as anything but a Model 2.
> 
> > Correct: 010 is defined in DMKRIO as 3277 (model 2) and it is the
> primary
> console.
> 
> > > I'm also quite sure of is that the 43x80 model 4 did not exist until
> the
> > > advent of the 3278 which had to have a 3274 CU.
> 
> > > Another thing I'm sure of is that the 3274 and 3278/9 were not around
> when
> > > VM370 Rel 6 was current.
> 
> > Uncorrect; 3278 and 3274 were announced in 1977.
> >
> > > Also recall that there is no real full screen 3270 screen I/O support
> in
> CP
> > In our SixPack VM/370 there's a full screen application (the fantastic
> GCIC editor written by Rocky) the works with a dialed terminal.
> >
> > BFN
> 
> Clarification - the 3215 CMS console is line Mode - Diagnose 58 does not
> support Full screen on release 6
> But dialed SIO supports whatever it is programmed to support. Model 2 3 or
> 4
> 
> RUNGIC from CMSUSER
> Then dial cmsuser
> 
> It will aslo support IND$FILE in CUT MODE --- Definitely a full screen app
> 
> Roc
> 
> 
> 
> >
> > Paul
> >
> 
> 
> 
> 
> 
> ------------------------------------
> 
> Yahoo! Groups Links
> 
> 
>