[PATCH v17 28/34] hw/s390x/ipl: Set IPIB flags for secure IPL

If `-M secure-boot=on` is specified on the command line option, indicating
true secure IPL enabled, set Secure-IPL bit and IPL-Information-Report
bit on in IPIB Flags field, and trigger true secure IPL in the S390 BIOS.

Any error that occurs during true secure IPL will cause the IPL to
terminate.

Signed-off-by: Zhuoying Cai <[email protected]>
Reviewed-by: Thomas Huth <[email protected]>
Reviewed-by: Collin Walling <[email protected]>
---
 hw/s390x/ipl.c | 28 +++++++++++++++++++++++-----
 1 file changed, 23 insertions(+), 5 deletions(-)

diff --git a/hw/s390x/ipl.c b/hw/s390x/ipl.c
index d0dbf47d74..08294af4d0 100644
--- a/hw/s390x/ipl.c
+++ b/hw/s390x/ipl.c
@@ -468,15 +468,30 @@ static bool s390_has_certificate(void)
     return ipl->cert_store.count > 0;
 }
 
+static bool s390_secure_boot_enabled(void)
+{
+    return S390_CCW_MACHINE(qdev_get_machine())->secure_boot;
+}
+
 static void s390_set_secure_boot_flags(IplParameterBlock *iplb,
-                                       bool audit_mode)
+                                       bool secure_boot, bool audit_mode)
 {
-    if (!audit_mode) {
+    if (!secure_boot && !audit_mode) {
         return;
     }
 
     /*
-     * For audit mode, enable the IPL Information
+     * If secure-boot is enabled, then toggle the secure IPL flags (SIPL) to
+     * trigger secure boot in the s390 BIOS.
+     *
+     * Boot process will terminate if any error occurs during secure boot.
+     */
+    if (secure_boot) {
+        iplb->hdr_flags |= DIAG308_IPIB_FLAGS_SIPL;
+    }
+
+    /*
+     * For both secure boot and audit mode, enable the IPL Information
      * Report (IPLIR) flag so that the firmware generates an IPL
      * Information Report Block (IIRB).
      *
@@ -545,7 +560,8 @@ static bool s390_build_iplb(DeviceState *dev_st, IplParameterBlock *iplb)
         s390_ipl_convert_loadparm((char *)lp, iplb->loadparm);
         iplb->flags |= DIAG308_FLAGS_LP_VALID;
 
-        s390_set_secure_boot_flags(iplb, s390_has_certificate());
+        s390_set_secure_boot_flags(iplb, s390_secure_boot_enabled(),
+                                   s390_has_certificate());
 
         return true;
     }
@@ -699,7 +715,9 @@ void s390_ipl_update_diag308(IplParameterBlock *iplb)
          * The kernel does not preserve secure boot flags across a reboot.
          * Re-apply them here based on the current machine configuration.
          */
-        s390_set_secure_boot_flags(&ipl->iplb, s390_has_certificate());
+        s390_set_secure_boot_flags(&ipl->iplb,
+                                   s390_secure_boot_enabled(),
+                                   s390_has_certificate());
     }
 
     update_machine_ipl_properties(iplb);
-- 
2.55.0