Re: gprof store and reset pins

Thanks a lot for the tips. I ended up doing the 'monitor' commands - i.e.

	monitor set gprof reset 1
	monitor set gprof store 1

(actually since I'm directly writing through the socket to the gdb component,
I ended up passing a "qRcmd,<hex-coded-command>" string).

- Nikola Valerjev

On Sat, 18 Oct 2003, Frank Ch. Eigler wrote:

> Hi -
> 
> 
> On Fri, Oct 17, 2003 at 12:41:14PM -0700, Nikola Valerjev wrote:
> > [...]
> > I've been trying to use gdb and gprof components in 'sid' to get the profiling
> > information out. [...]
> 
> I'm glad to hear it!
> 
> > What I would like to do is get gmon.out dumped while still being connected.
> > Also I would like to have some way of reseting the gprof info (driving the
> > 'reset' pin) on demand [...]
> 
> Since both these signals are carried over generic sid pins, any mechanism
> at all that can result in pin events at times of your pleasure will work.
> Among them:
> - time-based scheduler events (host or target)
> - hard-wired connection between the "save" and "reset" pins, probably
>   through a hw-glue-sequence; hmm, finding a way of automatically changing
>   the profiling data file name might be nice
> - socket or console input
> - memory-mapped I/O (mapping hw-glue-probe-bus components into memory,
>   connecting one of its output lines to the pin of your choice)
> - using the gdb "monitor set COMPONENT ATTRIBUTE VALUE" command to
>   pass the "set ..." configuration line to cfgroot, thence to COMPONENT.
>   Consider COMPONENT=gprof, ATTRIBUTE=reset or save, VALUE=1, recalling
>   that most pins may be alternately driven using attribute-related calls.
> - using the gprof component's own pc-limit-range attributes to automatically
>   limit its focus to a certain span of PC values.
> 
> 
> - FChE
>