Re: use lib5250 without display
"Mark S. Waterbury" <[email protected]>
| Newsgroups | gmane.comp.emulators.tn5250 |
|---|---|
| Organization | Industrial Strength Software Company |
| Message-ID | <[email protected]> |
Visit http://www.think400.dk/downloads.htm and page down until you see Albert York's TNAPI tool. > On 6/15/2010 11:16 AM, Massimo Corà wrote: > Hi all, > > probably this question has already been asked but I didn't find any > reference on mailing list archives. > > Is there a way to setup a communication with an as400 host without using > a local display/terminal where to show the data received/sent? > I'd like to run some macros on as400 and as such I don't need a visual > feedback. The session would then be controlled by a macros-engine. I > suppose I have to implement a "non-display" dummy display? > > thanks and regards, > Massimo > > -- This is the Linux 5250 Development Project (LINUX5250) mailing list To post a message email: LINUX5250-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/linux5250 or email: LINUX5250-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/linux5250.