Re: Question about lp5250d and SCS2ASCII
"Alberto" <a.ernestini-UVFfO7pX/[email protected]>
| Newsgroups | gmane.comp.emulators.tn5250 |
|---|---|
| Organization | midrange.com |
| Message-ID | <[email protected]> |
Hello James, after some further tests i am almost sure that the main cause of the "split" is the *WSCST file i've created for handle with spool files > 198 chars. So using a standard HPT table solves the problem, and also using a *HP4 HPT Table with the minimum modifications for handle with 198 chars seems works well the same. My tests was both on V5R2M0 and V5R4M0 at the lastest PTF Level. I also have the "bad" Wscst file stored if you want it for any test :-) Thanks! Ciao. Alberto. "James Rich" <[email protected]> ha scritto nel messaggio news:mailman.30072.1274979708.2580.linux5250-Zwy7GipZuJitq2lpoERdew@public.gmane.org > On Thu, 27 May 2010, Alberto wrote: > >> Hi to all :-) >> I was wondering if there is any update about this thread :-) >> I hope so ! > > Alberto, I am very busy with a project for the next two weeks. I won't > have much time to look at this during that time. I'm inclined to agree > with Scott that something in the Host Print Transform is causing lp5250d > to see End Of File, but I don't know what. I'll do what I can, but I will > be slow to respond for a while. > > James Rich > > if you want to understand why that is, there are many good books on > the design of operating systems. please pass them along to redmond > when you're done reading them :) > - Paul Davis on ardour-dev -- This is the Linux 5250 Development Project (LINUX5250) mailing list To post a message email: LINUX5250-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/linux5250 or email: LINUX5250-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/linux5250.