Problem with TN5250

Trying to use TN5250 here on a Debian box. It works fine until we get an
error message and then it locks up the whole session and we have to close
the window and restart it. Unfortunately that is a non-starter. 

This is not a "critical" error... just a warning, in this case, it's telling
us that we haven't entered any roll numbers for the carpet and we should
enter some roll numbers... but we can't get that far because it's blocking
us. On the official Windows 5250 client, we just hit "ctl" and it goes away
and we can proceed. However, that doesn't work for us with TN5250.

Any suggestions would be appreciated.





-- 
This is the Linux 5250 Development Project (LINUX5250) mailing list
To post a message email: LINUX5250-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/linux5250
or email: LINUX5250-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/linux5250.