Re: Re: IMS/DB on MVS 3.8J
Mike Stramba <[email protected]>
| Newsgroups | gmane.comp.emulators.turnkey-mvs |
|---|---|
| Message-ID | <[email protected]> |
Ran into first snag. Running the IEHMOVE job, I mounted the tape on 580, when I reply 0,580, the console just keeps saying " ..... device name" .... (didn't capture the exact message) Is it maybe because the JCL has : TAPE DD DSN=TAPE,UNIT=TAPE,VO UNIT=TAPE .... instead of a specifice device # ? Will try again, and edit the jcl to put a device # (580) for the unit param On 3/12/10, Mike Stramba <[email protected]> wrote: > Kevin, > > Great ! > > Thx ! > > Mike > > > On 3/12/10, Kevin Monceaux <[email protected]> wrote: >> Mike, >> >> On Fri, Mar 12, 2010 at 01:31:57AM -0500, Mike Stramba wrote: >> >>> So does it work at all under MVT ? >> >> Yes. The version available is for MVT. There was a problem reading the >> distribution tape. Some of the source is, or at least was, unavailable >> which caused challenges with getting it working under MVS. >> >>> If so ,do you have any DASD / tapes .. other that I can load into MVT >>> ? >> >> Yes. In fact when I went to upload the test jobs earlier I found I had >> previously uploaded the tape and restore/install jobs for someone else at >> some point in the past. They're available at: >> >> http://www.RawFedDogs.net/static/DLI.aws >> >> http://www.RawFedDogs.net/static/RestoreJobs.tar.bz2 >> >> http://www.RawFedDogs.net/static/DLIjobs.tar.bz2 >> >> >> -- >> >> Kevin >> http://www.RawFedDogs.net >> http://www.WacoAgilityGroup.org >> Bruceville, TX >> >> What's the definition of a legacy system? One that works! >> Si hoc legere scis nimium eruditionis habes. >> Longum iter est per praecepta, breve et efficax per exempla!!! >> >> >