Re: can we club assist with mvs tk3

Mike Schwab <[email protected]>
Newsgroups gmane.comp.emulators.turnkey-mvs
Message-ID <[email protected]> 
Not sure if the assist emulator is installed.  The IFOX assembler is
available and a superset been created to use some 31 bit addressing
instructions for the MVS/380 project.  And single stepping and trace
instructions are available with Hercules.

On Sun, Mar 28, 2010 at 3:07 AM, amit.arora275 <[email protected]> wrote:
> can we write advanced macros in assist and prog using various access method.

-- 
Mike A Schwab, Springfield IL USA
Where do Forest Rangers go to get away from it all?
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.