RE: can we club assist with mvs tk3

ASSIST is installed in the VM/370 4/5/pack so its around. VM/370 also has
the PER mods installed for tracing..

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of Mike Schwab
> Sent: 28 March 2010 14:34
> To: [email protected]
> Subject: Re: [turnkey-mvs] can we club assist with mvs tk3
> 
> 
> Not sure if the assist emulator is installed.  The IFOX 
> assembler is available and a superset been created to use 
> some 31 bit addressing instructions for the MVS/380 project.  
> And single stepping and trace instructions are available with 
> Hercules.
> 
> On Sun, Mar 28, 2010 at 3:07 AM, amit.arora275 
> <[email protected]> wrote:
> > can we write advanced macros in assist and prog using 
> various access 
> > method.
> 
> -- 
> Mike A Schwab, Springfield IL USA
> Where do Forest Rangers go to get away from it all?
> 
> 
> ------------------------------------
> 
> Yahoo! Groups Links
> 
> 
>