Re: Trouble Trying to install latest RPF

--- In [email protected], "halfmeg" <opplr@...> wrote:
>
> > Ron Hudson wrote:
> 
> > Hi All...
>  
> > I am having problems with the built in RPF in turnkey (No matter
> > what I do I get Alloc errors while trying to edit existing files)
> 
> Possible indication that your configuration doesn't match TK3.  Do you get messages on MVS console or only in RPF ?  If on console, cut and paste so we can see what is going on.
>  
> > So I decided to try the latest version of RPF. I am following the
> > instructions at:
> 
> > http://www.timpinkawa.net/hercules/rpf.html
>  
> > I devinit the rpfjcl file (which somehow got named rpf153 instead of
> > rpfjcl.tx do I need to change it back?)  Nothing seems to happen.
> 
> Tim's page may refer to a earlier release of RPF ( there were 2 RPF153 IIRC ).  You should not have to change anything AFAICR.
> 
> > I don't get the job start line on the master console, I don't get
> > the line asking me to mount the tape. nothing.
> 
> Because your job hasn't entered the system yet, see below.
> 
> > remember, I am that noob guy.
> 
> > Another strange thing is my RDR device is
> > 010C, not 000C as shown in the instructions.
>  
> > I don't seem to have a 000C device.
> 
> Another indication that your configuration file doesn't match TK3.  If you did a 'devinit 10C' then your job has never entered the system at all as 10C is not under JES2 control and was never meant to be.  Even if you were to start a reader on 10c, the configuration glitch you seem to have might prevent installation of the newer RPF.
> 
> Phil
>
So does that mean I just need to change my RDR to 000C? there does not seem to be a device assigned there now.

Or Perhaps I can place 010C under JES2 control?