Re: Re: In over my head again...

LISTC LEVEL('USER01')

ENTRY USER01. NOT FOUND+
LASTCC=4

LISTC LEVEL('SYS1')

[LOTS
    OF
       STUFF]

is there a listc that would list

sys1,  sys2,  and what else?


On Sun, Apr 25, 2010 at 5:17 AM, halfmeg <[email protected]> wrote:

>
>
>
>
> > Ron Hudson wrote:
>
> ><liberal snips>
>
>
> > I have used dasdinit to create a new 3350 DASD (300 mb goes a long
> > way right?)
>
> Jay's comment with that JCL mentions using half of the available space. I
> haven't run his install in quite a while and don't remember if that part was
> in the main stream of his build. If the catalog takes 150 MB of your pack,
> you might want to consider reducing the size of the catalog.
>
>
> > 00130 DEFINE ALIAS (NAME (USER01) -
>
> Not sure if this is your problem or not. I seem to remember if you already
> have a high level in the catalog it won't let you define an ALIAS with the
> high level.
>
> In other words, you will probably need to be sure no USER01.xxx.xxx
> datasets are cataloged in the master cat before running your job to create
> the alias for USER01.
>
> Phil
>
>  
>