Re: Re: In over my head again...
Rick Fochtman <[email protected]>
| Newsgroups | gmane.comp.emulators.turnkey-mvs |
|---|---|
| Message-ID | <[email protected]> |
Try doing a LISTC without any operands. This should list the MASTER
CATALOG for you.
Rick
-------------------------------------------------
Ron Hudson wrote:
>
>
> LISTC LEVEL('USER01')
>
> ENTRY USER01. NOT FOUND+
> LASTCC=4
>
> LISTC LEVEL('SYS1')
>
> [LOTS
> OF
> STUFF]
>
> is there a listc that would list
>
> sys1, sys2, and what else?
>
>
> On Sun, Apr 25, 2010 at 5:17 AM, halfmeg <[email protected]
> <mailto:[email protected]>> wrote:
>
>
>
>
>
> > Ron Hudson wrote:
>
> ><liberal snips>
>
>
>
> > I have used dasdinit to create a new 3350 DASD (300 mb goes a long
> > way right?)
>
> Jay's comment with that JCL mentions using half of the available
> space. I haven't run his install in quite a while and don't
> remember if that part was in the main stream of his build. If the
> catalog takes 150 MB of your pack, you might want to consider
> reducing the size of the catalog.
>
>
> > 00130 DEFINE ALIAS (NAME (USER01) -
>
> Not sure if this is your problem or not. I seem to remember if you
> already have a high level in the catalog it won't let you define
> an ALIAS with the high level.
>
> In other words, you will probably need to be sure no
> USER01.xxx.xxx datasets are cataloged in the master cat before
> running your job to create the alias for USER01.
>
> Phil
>
>
>