Re: oh my jes2 Resources.

On 5/5/2010 3:14 PM, Ron Hudson wrote:
> so I try to purge/stop the jobe with:  P jobnumber  at console a (dev 011)

To stop MVS from executing a job, you need to cancel it:
  C jobname

to remove JES2 output for the job, you need $PJnnn

The error responses you are getting are misleading, because MVS 
doesn't know about JES2 job numbers Jnnnn, and while JES2 knows 
about job names, commands to use them don't exist in the tk 
version of JES2 .

> Ipl again. seems normal until just after the r 00,clpa then it prints
> the normal few lines
> and is just sitting there - I guess it's finishing up it's thinking from
> when it was so rudely
> interrupted.

No. It's not starting any work because there is no spool space, 
and won't be until you free up some:

$PJ1-9999  (not usually safe - deletes all your jobs)
$PT1-9999  (removes TSO session output)
$PS1-9999  (removes output for started jobs)

> How *do* you stop a job that has gone off the rails?

All of this information is covered in Volker's cookbook that 
came with the turnkey. However, frequently you need a bad 
experience and a reread before it starts making sense <G>


Gerhard Postpischil
Bradford, VT


------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/turnkey-mvs/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/turnkey-mvs/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/