Re: oh my jes2 Resources.

Try "$PJ1-9999 command before you format...........

Rick
-------------------------------------------------------
Ron Hudson wrote:

>  
>
>
>
> On Wed, May 5, 2010 at 1:22 PM, Gerhard Postpischil 
> <[email protected] <mailto:[email protected]>> wrote:
>
>      
>     On 5/5/2010 4:05 PM, Ron Hudson wrote:
>     > The commands below that purge various queues $PS1-9999 for example
>     > all of them say "Not Executed"
>
>     I'm not aware of any such response. All MVS messages have a
>     letter/number prefix, and the JES2 messages have a
>     $/letter/number prefix.
>
>
> JES2 did not initialize, I think it was trying to start. 
>
>
>     Did the IPL complete, i.e., did JES2 initialize. How far did the
>     IPL get? You mentioned a CMB shortage - does this message
>
>
> The message persisted most of the morning - JES2 was the
> only thing listed in the D a,l command that and some "Starting"
>
>  
>
>
>     persist, or did it clear up (the message and clearing up is
>     normal at IPL time).
>
>     Gerhard Postpischil
>     Bradford, VT
>
>
> I IPL'ed a second time and JES2 got into a more useful state where
> it would accept the $Px1-9999 commands. I still have a
>
> $HASP093 100% SPOOL UTILIZATION
>
> And I think I need to restart JES2 with PARM='FORMAT,NOREQ' to resolve 
> that.
>
> (you may have mentioned something else earlier in this thread - I have 
> to go back and
> look)
>
> Ron.
>
>  
>
>
>