Re: oh my jes2 Resources.

That command reminded me of the original job and said it was waiting to
purge it for some reason.

A number of  IPLs finally cleared everything  up.

Thanks.


On Wed, May 5, 2010 at 2:32 PM, Rick Fochtman <[email protected]> wrote:

>
>
> Try "$PJ1-9999 command before you format...........
>
> Rick
> -------------------------------------------------------
>
> Ron Hudson wrote:
>
>
>
>
>
>  On Wed, May 5, 2010 at 1:22 PM, Gerhard Postpischil <[email protected]
> > wrote:
>
>>
>>  On 5/5/2010 4:05 PM, Ron Hudson wrote:
>> > The commands below that purge various queues $PS1-9999 for example
>> > all of them say "Not Executed"
>>
>>  I'm not aware of any such response. All MVS messages have a
>> letter/number prefix, and the JES2 messages have a
>> $/letter/number prefix.
>>
>
> JES2 did not initialize, I think it was trying to start.
>
>>
>> Did the IPL complete, i.e., did JES2 initialize. How far did the
>> IPL get? You mentioned a CMB shortage - does this message
>>
>
> The message persisted most of the morning - JES2 was the
> only thing listed in the D a,l command that and some "Starting"
>
>
>
>>
>> persist, or did it clear up (the message and clearing up is
>> normal at IPL time).
>>
>> Gerhard Postpischil
>> Bradford, VT
>>
>
> I IPL'ed a second time and JES2 got into a more useful state where
> it would accept the $Px1-9999 commands. I still have a
>
> $HASP093 100% SPOOL UTILIZATION
>
> And I think I need to restart JES2 with PARM='FORMAT,NOREQ' to resolve
> that.
>
> (you may have mentioned something else earlier in this thread - I have to
> go back and
> look)
>
> Ron.
>
>
>
>>
>
>  
>