Re: RPF - INPUT CONVERT FAILED

--- In [email protected], Ron Hudson <hudson.ra@...> wrote:
>
> Hey DadKool,
> 
> I went and looked at the RPF user's guide and found "Input Convert Failed"
> but it looks
> like it only comes out when one makes some entry on the command area (not
> the
> number area or the text area the one line up near the top) when the editor
> is expecting
> "END" or "RETRY". Did the next message mention "End" & "Retry" ?
> 
> 
> (RPF user's guide page 33)
> 
> Ron.
> 
> On Tue, May 11, 2010 at 7:32 PM, dadkool <kool6@...> wrote:
> 
> >
> >
> > I'm trying to edit "ADDUSER". When I change the HLQ=USERID and hit enter I
> > get the message "INPUT CONVERT FAILED". The RPF manual doesn't explain why
> > this message occurs. Can anyone tell me what the problem is?
> > Thanks.
> >
> >  
> >
>

Ron,

Yes I did. When I enter "END", RPF leaves edit mode. When I edit the job again, my change does not show up.