Re: Why am I getting this HHCCP027E Device 0148 not in configuration...

Hello Kevin,

Thank you for your post. Not to waste space, can you take a look at my response to ScottC. Ok, you say I need this and all other dasd file in my config. Fine. I will now take a good look at the file you said to look at.

--- In [email protected], Kevin Monceaux <Kevin@...> wrote:
>
> Anyanso,
> 
> On Thu, May 13, 2010 at 06:38:30PM -0000, Anyanso wrote:
>  
> > The problem: Hercules MVS3.8j is up 
> 
> No, only Hercules is up.
> 
> > However, according to "Operating the MVS 3.8J Tur(n)key System" document,
> > the next thing should be to issue ipl 148 
> 
> Since you haven't successfully IPLd yet MVS isn't up.
> 
> > What could I be doing wrong 
> 
> There's not a single DASD volume in your config file.  The MVSRES volume
> should be at address 148.  Mine looks something like:
> 
> 0148 3350 dasd/mvsres.148  ro sf=shadow/mvsres_1.148
> 
> There should be several other DASD volumes in your config file also.
> 
> > and how can I go about resolving this problem?
> 
> Use a complete config file.  It's been a while since I performed a fresh
> install of the Turnkey system.  Looking at my current setup there is a
> config directory with more config files than one can shake a stick at.  The
> config file I use is config/turnkey_mvs.conf .  Do you have such a file with
> your Turnkey installation?  If so, it might be worth a try.  :-)
> 
> 
> -- 
> 
> Kevin
> http://www.RawFedDogs.net
> http://www.WacoAgilityGroup.org
> Bruceville, TX
> 
> What's the definition of a legacy system?  One that works! 
> Errare humanum est, ignoscere caninum.
>