Re: Re: Why am I getting this HHCCP027E Device 0148 not in configuration...

Hello  Anyanso,

If you haven't downloaded the Hercules manuals start with this one

http://www.ibiblio.org/jmaynard/herc307/HerculesUserReference.pdf

and get the rest here :http://www.hercules-390.org/

Then look at "operation" in the Turnkey cookbook.

You should have a "startmvs".bat .cmd file in directory that you
installed the turnkey system.

You can start Hercules with that, or copy the config file that
startmvs is using from the conf directory to where you've installed
the turnkey and start hercules from there, by just typing 'hercules'
at the dos prompt . (Assuming you've put the Hercules directory in
your path).

There is no "mvs" config file, it's a Hercules config file.

The contents of the config file will vary depending if you're running
MVS / VM .. etc (i.e. any O.S. that Hercules supports), or even a
custom written O.S.

At a minimum, the config file will usually have :

- one or more dasd  config statements
   These tell Hercules where you're dasd files are (virtual disk drives).

- one or more 3270 or telnet terminal definition(s)

See "What is the relationship between an MVS device, the Hercules'
configuration, and the host OS file (or client)?:

http://www.jaymoseley.com/hercules/installmvs/mvsfaq00.htm#General008

Mike

On 5/13/10, Anyanso <[email protected]> wrote:
>
>
>
> Hello MIke,
>
> Yes, I did download the turnkey iso. I may very well not have installed it
> correctly but I did follow the process Volker Bandke had written. Here is
> the Turnkey package that I am using
>     --> hercules-3.03_msvc_32.exe
> when I etracted and run the install setup program, it did put a bunch of
> file in a folder named \hercules\mvs38j\dasd\. Isn't that where it should be
> looking for these dasd files?
>
> Iten#2 - No dasd in the config. Which config? Hercules or mvs? How or what
> put these dasd file in the config?
>
> --- In [email protected], Mike Stramba <mikestramba@...> wrote:
>>
>> Hello  Anyanso,
>>
>> Hmm,
>>
>> 1) Have you downloaded the Turnkey CD / ISO ?
>> http://www.ibiblio.org/jmaynard/turnkey-mvs-3.zip
>>
>> If not, then you don't have any DASD (disk drives) devices, where the
>> MVS O.S. is.
>>
>> If so, you haven't installed it properly, check the cookbook, and post
>> back here.
>>
>> 2) You don't have any dasd devices in your config file, and there are
>> some other "non Turnkey"
>>     items in there (> ARCHMODE  z/Arch,   PGMPRDOS  LICENSED).
>>
>> I'm guessing that maybe you've downloaded Hercules, and have manually
>> created the config file,
>> but haven't downloaded the turnkey system ?
>>
>> Mike
>>
>
>
>