Re: Compile and run later
Mike Stramba <[email protected]>
| Newsgroups | gmane.comp.emulators.turnkey-mvs |
|---|---|
| Message-ID | <[email protected]> |
Rick, Where do you setup "global implicit" libraries ? Add a STEPLIB to the logon proecedure in SYS1.PROCLIB(TSOLOGON) ? Mike On 5/19/10, Rick Fochtman <[email protected]> wrote: > -------------------------------<snip>---------------------------- > >> >> >> Well grid may have not been a good choice for this exercise, it prints >> out stuff (lots of stuff) >> and requires a >> >> FT006F001 dd sysout=a >> >> JCL line... >> >> So... I am working with a different piece of JCL to run it from the >> linklib: >> >> //RGRID JOB (PROD),'PRODUCTION', >> // CLASS=A,MSGCLASS=A,MSGLEVEL=(1,1) >> //GRID EXEC PGM=GRID >> //FT06F001 DD SYSOUT=A >> >> And this seems to find grid - >> At first I had " 'HUDSON.LINKLIB(GRID)' " but it complained of the >> single quotes >> so I removed them... >> >> then I tried HUDSON.LINKLIB(GRID) (no quotes) and it complained of >> the dot. >> then I tried LINKLIB(GRID) and it then complained of the parentheses. >> so now it's just as you see it above PGM=GRID.. >> No complaints but an 806 abend... >> >> I gotta go look up a system 806 abend now .. aaand I am back - >> hmm it can't find my program ... >> but it does not want to be told 'HUDSON.LINKLIB(GRID)' either with or >> without single quotes. >> > ----------------------------<unsnip>--------------------------------- > Add the following JCL statement: > > //STEPLIB DD DSN=HUDSON.LINKLIB,DISP=SHR > > Note that STEPLIB is a special name, as is JOBLIB, but the placements > are different. > Put the STEPLIB card after the EXEC card. >