Re: Re: Compile and run later
Ron Hudson <[email protected]>
| Newsgroups | gmane.comp.emulators.turnkey-mvs |
|---|---|
| Message-ID | <[email protected]> |
On Wed, May 19, 2010 at 2:13 PM, Mike Stramba <[email protected]> wrote: > > > You can use DVOL to check the disk space. > Wow there is a lot DVOL is trying to tell me.... > > You may have just allocated the PDS with not enough space to start > with. Or too few "directory" entreis (slots for PDS members). > > PDS's are fixed size files, unlike the dynamic sized files on P.C's, / > Linux. > > Look in the RPF dataset list, the # of remaining directory entries for > the PDS is under the FREE column. > I was using space=(cyl,(10,,30)) I deleted the PDS and used space=(cyl,(10,10,30)) once and then used disp=(,catlg,) afterward. Now my linklib has two members. Grid and UlamsLD > > If you are in fact out of *disk* space, you can create another volume > (virtual dasd) by following Jay's instructions : > > http://www.jaymoseley.com/hercules/installmvs/adddasd.htm > >