Re: Re: The best place to begin learning Assembler

scott <[email protected]> Fri, 28 May 2010 00:10:09 -0400

Newsgroups	gmane.comp.emulators.turnkey-mvs
Message-ID	<[email protected]>

On 05/27/2010 09:42 PM, Ron Hudson wrote:
>
>
>
>
> On Thu, May 27, 2010 at 6:29 PM, kerravon86 <kerravon86-/[email protected]
> <mailto:kerravon86-/[email protected]>> wrote:
>
>      
>     --- In [email protected]
>     <mailto:turnkey-mvs%40yahoogroups.com>, Ron Hudson <hudson.ra@...>
>     wrote:
>     >
>     > Sounds like um ...fun...
>     >
>     so just point your IFOX00 SYSIN to
>     MVSSRC.SYM202.F14(IEBGENRT)
>
> I don't seem to have any hlq mvssrc
>
> > Just use pre-canned code for that.
>
> Unless it has very good comments I won't learn anything from it as far
> as idiom goes.
>
>
>
>
  If you want to learn assembler I suggest Mike Muroch's book. 
http://www.murach.com/books/mbal/index.htm