Re: Win2k and CIPE

On Tue, 2 Sep 2003, Phil Scarratt wrote:

> Jake Bullet wrote:
> >>
> >>With the following assumptions:
> >>- CIPE tunnel between Alice and Bob with CIPE IP addresses 172.16.0.1/2
> >>- Bob and Chris are on the same LAN with LAN IP addresses 172.16.1.1/2
> >>- Bob is Chris' default gateway
> >>Adding a route to Alice for the Bob-Chris LAN (route add 172.16.1.0 mask 
> >>255.255.255.0 172.16.0.1) should allow packets to get from Alice to 
> >>Chris and back.
> >>
> >>If however, the following scenario presents itself:
> >>- CIPE tunnel between Alice and Bob with IP addresses as marked above
> >>- CIPE tunnel between Bob and Chris with IP addresses as marked above
> >>then the following should work (never done this so totally untested):
> >>- add route to Alice that points to 172.16.1.0 (route add 172.16.1.0 
> >>mask 255.255.255.0 172.16.0.1)
> >>- add route to Chris that points to 172.16.0.0 (route add 172.16.0.0 
> >>mask 255.255.255.0 172.16.1.1)
> >>
> > 
> > 
> > That's not quiet it, as Chris is also running CIPE to Bob.  I did try this
> > but the Server (Bob) didn't seem to be routing the packets.
> > I did turn on IP forwarding.  Running TCP dump on both CIPE interfaces
> > showed Alice sending the ECHO REQUEST to Bob, and that's where it stopped.
> > 
> > As mentioned lots of these were showing up in the syslog:
> > 
> > May  6 01:21:37 bob kernel: cipcb2: got bogus length=9
> > May  6 01:21:37 bob kernel: cipcb1: got bogus length=9
> > 
> > Stephen
> > 
> 
> Is there a firewall running on Bob? What's the routing table for Bob 
> look like?
> 

There is no firewall running on Bob for the CIPE interfaces, and the
routing table is empty.

Stephen


--
Message sent by the [email protected] mailing list.
Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
Other commands available with "help" in body to the same address.
CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>