Re: Win2k and CIPE
Jake Bullet <[email protected]>
| Newsgroups | gmane.comp.encryption.cipe |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 2 Sep 2003, Phil Scarratt wrote: [snip] > > > > What do I need to add? > > > > I was planning on having a whole big system of Win2k clients, all on > > different subnets. Will I need a massive routing table to get them all > > talking to each other? > > > > Stephen > > > > I'm a little confused here, as when cipe starts successfully on linux, > routes are automatically added for the other end of the tunnel. In other > words, starting cipcb0 (whose ip is 172.16.0.1 and peer is 172.16.0.2) > should add at least the following to the route table: > > 172.16.0.2 * 255.255.255.255 U 0 0 0 cipcb0 > > If these are not appearing then something strange is going on - are you > sure the tunnel is starting correctly?? > Okay, what I should have said was "I've not added anything to the routing table" rather than saying it was empty. With alice(cipcb0) and chris's(cipcb1) interface enabled it looks like this: Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 172.16.0.2 * 255.255.255.255 UH 0 0 0 cipcb0 172.16.1.2 * 255.255.255.255 UH 0 0 0 cipcb1 192.168.200.0 * 255.255.255.192 U 0 0 0 eth0 default 192.168.200.62 0.0.0.0 UG 0 0 0 eth0 -- Message sent by the [email protected] mailing list. Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body Other commands available with "help" in body to the same address. CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>