Re: CIPE RH linux + Windows 2000 routing problem
Phil Scarratt <[email protected]>
| Newsgroups | gmane.comp.encryption.cipe |
|---|---|
| Organization | Draxsen Technologies |
| Message-ID | <[email protected]> |
Hans Steegers wrote: > My guess: the problem is the netmask of the cipcb0 interface on the linux > gateway: > > Three possible solutions: > 1. Give the cipcb0 interface on the linux gateway a proper netmask > 255.255.255.0 > OR: > 2. Give the cipcb0 interface the same address/mask as eth1 > OR: > 3. Give the cipcb0 interface an address outside of the LAN subnet. I had trouble setting up a configuration between Win32 and Linux when using CIPE IP addresses that were on the same subnet as the linux network end. However, I had other problems with that particular setup which may have caused the problem instead of the ip address on the same subnet - haven't spent the time to confirm or deny it yet... Fil -- Message sent by the [email protected] mailing list. Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body Other commands available with "help" in body to the same address. CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>