Re: cipe-win32 service fails to start

Rob,

> Unzip files
> Install cipe adapter driver via hardware wizard
I think you MUST reboot here, even if Windows 2k erroneously does not 
ask you to do so (XP, however, does).

> edit cipe adapter IP config info
> edit cipe peer confg via control panel
>  - (should be up and running?)
The cipe service is normally running when you are done with the control 
panel.

> One other question: How does one properly deinstall the cipe _service_? I
> did not get it to disappear from the Service manager list.
Set do "Manual" and not manually started has the same effect as if it 
had not been installed.

I just wanted to propose to deinstall and reinstall TCP/IP (e.g. 
http://support.microsoft.com/?kbid=299451) to solve your problem but a 
fresh Windows installation is even better. I am sure it will work.


Carsten.


--
Message sent by the [email protected] mailing list.
Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
Other commands available with "help" in body to the same address.
CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>