Re: Quake 3 with cipe
Richard Gregory <[email protected]>
| Newsgroups | gmane.comp.encryption.cipe |
|---|---|
| Message-ID | <[email protected]> |
Yes tried that one and it works fine. 1:1 packet balance at 2-3K bytes per second. Its only through cipe that this problem shows up, which is why I came to the cipe list in search of an answer. This is what it comes down to, with Q3 on XP (or 2K) *and* cipe, there are 4* or more many packets going to the server as either without cipe (direct) or with Q3 on Linux via cipe. Strange stuff... Richard +-- --+ | Computer Science, Room G34 | | http://www.csc.liv.ac.uk/~greg | | Electrical Engineering, Room ~104 | +-- --+ Mark Smith wrote: > I'm sure it's probably obvious, but have you actually tried the same > configurations, but using a direct connection between client and server > rather than through CIPE, to prove that this specific problem isn't > something to do with your configuration? If it's different then sure, it > might be CIPE. If it's not, then I'd probably blame something inside Q3 > itself. > > -- > Mark Smith - Avco Systems Ltd > email: [email protected] > Tel: +44 (0)1784 430996 Fax: +44 (0)1784 431078 > > > -- > Message sent by the [email protected] mailing list. > Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body > Other commands available with "help" in body to the same address. > CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html> > -- Message sent by the [email protected] mailing list. Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body Other commands available with "help" in body to the same address. CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>