Re: No route to peer

Hello Ted,

I found the error. The /etc/init.d/cipe script has a error. It searches 
in /etc/sysconfig/network/ for ifcfg-ppp0 script. But there isn't... So 
I coppied the ifcfg-dsl0 and called the script ifcfg-ppp0. And 
everything is fine :-)

Thank you for the help.....

Michael

Ted Kaczmarek wrote:

>You can ping the peer ip?
>In your config you have the below?
>If you use tcpdump or ethereal do you see any cipe packets leaving ppp0?
>
>Also try strace or gdb to get more data.
>
>In your config do you have the below?
>TUNNELDEV=ppp0
>
>
>Example config from my Fedora Core 1 box.
>
>cat ifcfg-cipcb0
># Please read /usr/share/doc/initscripts-*/sysconfig.txt
># for the documentation of these parameters.
>USERCTL=no
>PEERDNS=no
>TYPE=CIPE
>DEVICE=cipcb0
>ONBOOT=yes
>IPADDR=192.168.242.1
>MYPORT=14567
>PTPADDR=192.168.242.2
>PEER=115.89.123:14567
>ME=117.90.19.98
>TUNNELDEV=eth0
>
>
>Ted
>
>On Tue, 2004-01-06 at 09:24, Michael Schmitz wrote:
>  
>
>>I can ping the internet ip. ppp0 is configered as my default connection. 
>>Should I config it elsewhere?
>>I disabled the firewall too.
>>
>>Ted Kaczmarek wrote:
>>
>>    
>>
>>>And you can ping the peer?
>>>You have ppp0 specified as the interface in your config?
>>>You don't have iptables or ipchains blocking it?
>>>
>>>Ted
>>>On Tue, 2004-01-06 at 04:30, Michael Schmitz wrote:
>>> 
>>>
>>>      
>>>
>>>>Hello Ted,
>>>>
>>>>I have a default route on my internet adress with the interface ppp0.
>>>>
>>>>CU Michael
>>>>
>>>>Ted Kaczmarek wrote:
>>>>
>>>>   
>>>>
>>>>        
>>>>
>>>>>Do you have a route for the peer?
>>>>>Ted
>>>>>
>>>>>On Sat, 2004-01-03 at 19:18, Michael Schmitz wrote:
>>>>>
>>>>>
>>>>>     
>>>>>
>>>>>          
>>>>>
>>>>>>Hello,
>>>>>>
>>>>>>I try to use CIPE with SUSE 8.2 and ADSL. Before this I used it with 
>>>>>>ISDN and it was fine....
>>>>>>But now I get a error message when I start the daemon:
>>>>>>for peer xy  Error: No route to peer....
>>>>>>I hope somebody can help me....
>>>>>>
>>>>>>THX Michael
>>>>>>
>>>>>>
>>>>>>       
>>>>>>
>>>>>>            
>>>>>>
>>    
>>
>
>
>  
>



--
Message sent by the [email protected] mailing list.
Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
Other commands available with "help" in body to the same address.
CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>