Re: Nat & Port forwarding

Hi Tommi,
thanks for the help.

I was thinking that dynip was need only in the server that has
a dinamic public IP address.

Will keep with the testing.

Oliver

Tommi Kyntola wrote:

> [email protected] wrote:
>
>>
>> Hi,
>> I'm trying to use cipe between 2 Linux servers, one with static
>> public IP address(server1), and another that connects to the
>> Internet via NAT with dinamic public address(server2).
>>
>> I wanted to know if I should enabled port-forwading in my NAT
>> router to my cipe server2 that has a private address.
>
>
> Port-forwarding is not necessary, with dynip turned on from
> the server side cipe config you can just aswell masquerade
> the ports as usual. Other (but not as flexible and redundantly
> complex) solution is to do port forwarding without the dynip
> and the set the peer to match the port forwarded machine, but
> I certainly don't recommend this, because it's far more easier
> with dynip turned on. After that it doesn't matter
> where your machines connect to the server.
>
>> I have setup my server1 to listen only, that is, its peer address
>> is 127.0.0.1:9
>
>
> Well, with dynip turne on it doesn't matter what you have there.
> 0.0.0.0 will do just fine, too.
>
>> As far as I understand, server2 will connect to server1 and
>> then, server2 will run the ping command in order to server1
>> to optain the IP address of server2.
>
>
> you should set
> dynip 1
> in you server1 config and set the server2 to
> ping 60
> (or whatever suits you.
>
>> Is this correct?
>
>
> Yes, but you musn't forget the dynip setting from the
> public static server.
>
>> Many thanks
>> Oliver
>>
>> -- 
>> Oliver Schulze L.
>> <[email protected]>
>>
>>
>> -- 
>> Message sent by the [email protected] mailing list.
>> Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
>> Other commands available with "help" in body to the same address.
>>  CIPE info and list archive:
>>  <URL:http://sites.inka.de/~bigred/devel/cipe.html>
>>
>
>
> -- 
> Message sent by the [email protected] mailing list.
> Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
> Other commands available with "help" in body to the same address.
> CIPE info and list archive: 
> <URL:http://sites.inka.de/~bigred/devel/cipe.html>


-- 
Oliver Schulze L.
<[email protected]>


--
Message sent by the [email protected] mailing list.
Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
Other commands available with "help" in body to the same address.
CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>