Re: interface not starting

Am Freitag, 10. M=E4rz 2006 22:24 schrieben Sie:
> Dirk Jakobsmeier writes:
> > i=C2=B4m having a problem while loading cipe module. After patching ver=
sion
> > 1.6.0 with patch for kernel 2.6.14 i could load module cipcb0 an got the
> > following messages in message file:
> >
> > kernel: cipcb: CIPE driver vers 1.6.0 (c) Olaf Titz 1996-2003, 100
> > channels, \ debug=3D1
> > kernel: cipcb: cipe_alloc_dev 0
> >
> > After that if i try to start the interface i got:
> >
> > /etc/dev.d/net/50-ifup.dev[17524]: SIOCSIFFLAGS: No such device or
> > address ifup: Cannot enable interface cipcb0
> > ifup-route: interface cipcb0 is not up
> >
> > Doing an ifconfig -a i can see cipcb0 but not without -a. So the
> > interface was not startet.
>
> The device won't be fully enabled until you have a ciped-cb daemon
> running - and the daemon won't stay running until it has a peer to
> talk to.
>
> Rather than trying to access a device that's not really there yet, try
> using it - bring up a tunnel, using pkcipe for example.
>
> --
Hello,

well, my problem is that on my remote server there is no pkcipe running. It=
 is=20
running a cipe daemon, waitiing for a connection. So i have to do it this=20
way. Using pkcipe means to use it on both sides i think (hopefully read=20
correct in documentation)?

Thanks for your answer.
=2D-=20

--
Message sent by the [email protected] mailing list.
Unsubscribe: mail [email protected], "unsubscribe cipe-l" in body
Other commands available with "help" in body to the same address.
CIPE info and list archive: <URL:http://sites.inka.de/~bigred/devel/cipe.html>