Continue Self Test on Error?

Hi All,

Does `testlib` have a switch to continue testing even on failure?

Jeff

$ ./testlib
...
Testing TLS 1.2 session...
  Remote host: https://tls.woodgrovebank.com:25000/.
Attempt to activate TLS 1.2 session failed with error code -25, line 1035.
  Error message = 'Timeout on connect (select()) after 30 seconds'.
  Error info attributes report locus 6009, type 3.

The test was aborted due to an error being detected.  If you want to report
this problem, please provide as much information as possible to allow it to
be diagnosed, for example the call stack, the location inside cryptlib where
the problem occurred, and the values of any variables that might be
relevant.

The error occurred during one of the network session tests, if the error
message indicates a network-level problem such as ECONNREFUSED, ECONNRESET,
or a timeout or read error then this is either due to a transient
networking problem or a firewall interfering with network connections.  This
isn't a cryptlib error, and doesn't need to be reported.
$

_______________________________________________
Cryptlib mailing list
[email protected] via Mail: [email protected]
Archive: ftp://ftp.franken.de/pub/crypt/cryptlib/archives/
http://news.gmane.org/gmane.comp.encryption.cryptlib
Posts from non-subscribed addresses are blocked to prevent spam, please
subscribe in order to post messages.