How to build OpenSC/libp11 ?
Jana Nguyen <[email protected]>
| Newsgroups | gmane.comp.encryption.opensc.devel |
|---|---|
| Message-ID | <CAGL8nR+ZbS+ohJqgPzF8PqjcEkBe-fHBA_GBEb9D2JW=RBTWrw@mail.gmail.com> |
Hello, I want to use OpenSC/libp11 for my project since I want to use the pkcs11 module to access HSM. I've cloned libp11 repo from the master branch, but how do I build it so I can start using it for Centos 6? I've looked at INSTALL.md at https://github.com/OpenSC/libp11/blob/master/INSTALL.md and it suggest I run the below to build libp11: ./configure && make && sudo make install There is no "configure" or "install" under this repo: drwxr-xr-x 2 jnguyen SECENG 4096 Aug 22 21:19 tests drwxr-xr-x 2 jnguyen SECENG 4096 Aug 22 21:19 src -rwxr-xr-x 1 jnguyen SECENG 7563 Aug 22 21:19 README.md -rwxr-xr-x 1 jnguyen SECENG 7529 Aug 22 21:19 NEWS -rwxr-xr-x 1 jnguyen SECENG 1454 Aug 22 21:19 make.rules.mak -rwxr-xr-x 1 jnguyen SECENG 139 Aug 22 21:19 Makefile.mak -rwxr-xr-x 1 jnguyen SECENG 784 Aug 22 21:19 Makefile.am drwxr-xr-x 2 jnguyen SECENG 4096 Aug 22 21:19 m4 -rwxr-xr-x 1 jnguyen SECENG 2346 Aug 22 21:19 INSTALL.md drwxr-xr-x 2 jnguyen SECENG 4096 Aug 22 21:19 doc -rwxr-xr-x 1 jnguyen SECENG 26528 Aug 22 21:19 COPYING -rwxr-xr-x 1 jnguyen SECENG 7888 Aug 22 21:19 configure.ac -rwxr-xr-x 1 jnguyen SECENG 49 Aug 22 21:19 bootstrap -rwxr-xr-x 1 jnguyen SECENG 2205 Aug 22 21:19 appveyor.yml drwxr-xr-x 2 jnguyen SECENG 4096 Aug 22 22:10 examples Thanks! ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Opensc-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/opensc-devel