Re: OpenSC with qemu (Gemplus support)

2017-09-06 14:48 GMT+02:00 Anton Gerasimov <[email protected]>:

> Hi,
>

Hello,


>
> I'm trying to get OpenSC working with qemu (qemu-system-x86_64). It
> emulates Gemplus token (lsusb output: 'ID 08e6:4433 Gemalto (was
> Gemplus) GemPC433-Swap'), and it is unclear to me if it is supported in
> OpenSC. It is listed as unsupported hardware [1], but the page for
> Gemplus itself says it is supported [2].
>
>
The GemPC433-swap is a smart card reader, not a smart card.
This reader is supported by my CCID driver
http://pcsclite.alioth.debian.org/ccid/supported.html#0x08E60x4433

This device is NOT listed as unsupported hardware [1].

The Gemplus GPK is a smart card (not a reader). As Douglas wrote it is a
very old card.

I am not sure to understand what qemu is used for.
Do you really emulate the smart card reader using qemu?

Bye

[1]
> https://github.com/OpenSC/OpenSC/wiki/Supported-
> hardware-(smart-cards-and-USB-tokens)
> [2] https://github.com/OpenSC/OpenSC/wiki/Gemplus-GPK-16k
>

-- 
 Dr. Ludovic Rousseau

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Opensc-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/opensc-devel