Re: [Fwd: Re: Arla-0.42 on OpenBSD-3.9]

>
> The 0.42 release from Arla has been tested on OpenBSD 3.8, to run
> correctly in 3.9 you will have to check out -current form cvs:
> installing arla-current from cvs:\\
> \begin{verbatim}
> > cp src.tar.gz sys.tzr.gz /usr/src
> # cd /usr/src; tar zxvf src.tar.gz; tar zxvf sys.tar.gz
> perform some kernel build magic up to make depend


I think the magic-part can be skipped. You need to have
the kernel sources in the ordinary place and it will end up fine.

> env CVS_RSH=ssh cvs -d [email protected]:/stacken-cvs \
>    checkout arla
> # pkg_add autoconf-2.59.tgz ; pkg_add automake-1.9.6p0.tgz
> # pkg_add libtool-1.5.22.tgz
> > AUTOCONF_VERSION=2.59 AUTOMAKE_VERSION=1.9 autoreconf -f -i
> > ./configure && make
> # make install && mkdir /afs
> # echo "/usr/arla/sbin/startarla" >> /etc/rc.securelevel
> # reboot
> \end{verbatim}
>
>
--
Some mornings, it's just not worth gnawing through the straps...

_______________________________________________
Arla-drinkers mailing list
[email protected]
https://lists.stacken.kth.se/mailman/listinfo/arla-drinkers