Re: extcarve - ext2,ext3,ext4 file carving tool
"Lakshmipathi.G" <[email protected]> Wed, 15 Jun 2011 19:26:59 +0530
| Newsgroups | gmane.comp.file-systems.ext3.user |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Jun 15, 2011 at 6:49 PM, Jidong Xiao <[email protected]> wrote: > My file system is ext3. > > In addition, my partition size is very large, it is 400GB. Is that a > problem? > > I tried extcarve at two machines, both got the same results, i.e., > only generated some 4KB non-sense files there. > > ext3 shouldn't be a problem. Give a try with "-i" option, for the third input provide 256 as input. So that , It'll try upto 1MB files. ---- Please enter increased block limit:(default is 12) :256 ---- Does that produce files greater than 4KB size ? > Jidong > -- ---- Cheers, Lakshmipathi.G FOSS Programmer. www.giis.co.in _______________________________________________ Ext3-users mailing list [email protected] https://www.redhat.com/mailman/listinfo/ext3-users