[PATCH 05/21] fs: jfs: Replace CURRENT_TIME_SEC by current_fs_time()

jfs uses nanosecond granularity for filesystem timestamps.
Only this assignemt is not using nanosecond granularity.
Use current_fs_time() to get the right nanosecond granularity.

Signed-off-by: Deepa Dinamani <[email protected]>
Cc: Dave Kleikamp <[email protected]>
Cc: [email protected]
---
 fs/jfs/ioctl.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/fs/jfs/ioctl.c b/fs/jfs/ioctl.c
index 8653cac..b52aedf 100644
--- a/fs/jfs/ioctl.c
+++ b/fs/jfs/ioctl.c
@@ -60,6 +60,7 @@ long jfs_ioctl(struct file *filp, unsigned int cmd, unsigned long arg)
 {
 	struct inode *inode = file_inode(filp);
 	struct jfs_inode_info *jfs_inode = JFS_IP(inode);
+	struct super_block *sb = inode->i_sb;
 	unsigned int flags;
 
 	switch (cmd) {
@@ -121,7 +122,7 @@ long jfs_ioctl(struct file *filp, unsigned int cmd, unsigned long arg)
 
 		jfs_set_inode_flags(inode);
 		inode_unlock(inode);
-		inode->i_ctime = CURRENT_TIME_SEC;
+		inode->i_ctime = current_fs_time(sb);
 		mark_inode_dirty(inode);
 setflags_out:
 		mnt_drop_write_file(filp);
@@ -130,7 +131,6 @@ setflags_out:
 
 	case FITRIM:
 	{
-		struct super_block *sb = inode->i_sb;
 		struct request_queue *q = bdev_get_queue(sb->s_bdev);
 		struct fstrim_range range;
 		s64 ret = 0;
-- 
1.9.1


------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e