Re: [PATCH v2 05/24] fs: jfs: Replace CURRENT_TIME_SEC by current_time()
Dave Kleikamp <[email protected]>
| Newsgroups | gmane.comp.file-systems.jfs.general,gmane.linux.file-systems,gmane.linux.kernel,gmane.linux.kernel.year-2038 |
|---|---|
| Message-ID | <[email protected]> |
On 06/19/2016 07:27 PM, Deepa Dinamani wrote: > jfs uses nanosecond granularity for filesystem timestamps. > Only this assignemt is not using nanosecond granularity. > Use current_time() to get the right granularity. > > Signed-off-by: Deepa Dinamani <[email protected]> > Cc: [email protected] Acked-by: Dave Kleikamp <[email protected]> > --- > fs/jfs/ioctl.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/fs/jfs/ioctl.c b/fs/jfs/ioctl.c > index 8653cac..b6fd1ff 100644 > --- a/fs/jfs/ioctl.c > +++ b/fs/jfs/ioctl.c > @@ -121,7 +121,7 @@ long jfs_ioctl(struct file *filp, unsigned int cmd, unsigned long arg) > > jfs_set_inode_flags(inode); > inode_unlock(inode); > - inode->i_ctime = CURRENT_TIME_SEC; > + inode->i_ctime = current_time(inode); > mark_inode_dirty(inode); > setflags_out: > mnt_drop_write_file(filp); > ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. http://sdm.link/zohomanageengine