[PATCH v4 07/26] fs: jfs: Replace CURRENT_TIME_SEC by current_time()

jfs uses nanosecond granularity for filesystem timestamps.
Only this assignment is not using nanosecond granularity.
Use current_time() to get the right granularity.

Signed-off-by: Deepa Dinamani <[email protected]>
Cc: Dave Kleikamp <[email protected]>
Acked-by: Dave Kleikamp <[email protected]>
Reviewed-by: Arnd Bergmann <[email protected]>
Cc: [email protected]
---
 fs/jfs/ioctl.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/fs/jfs/ioctl.c b/fs/jfs/ioctl.c
index 8653cac..b6fd1ff 100644
--- a/fs/jfs/ioctl.c
+++ b/fs/jfs/ioctl.c
@@ -121,7 +121,7 @@ long jfs_ioctl(struct file *filp, unsigned int cmd, unsigned long arg)
 
 		jfs_set_inode_flags(inode);
 		inode_unlock(inode);
-		inode->i_ctime = CURRENT_TIME_SEC;
+		inode->i_ctime = current_time(inode);
 		mark_inode_dirty(inode);
 setflags_out:
 		mnt_drop_write_file(filp);
-- 
1.9.1


------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. http://sdm.link/zohodev2dev