Re: [RESEND PATCH] fs: jfs: Replace CURRENT_TIME_SEC by current_time()

On 11/11/2016 12:00 PM, Deepa Dinamani wrote:
> jfs uses nanosecond granularity for filesystem timestamps.
> Only this assignment is not using nanosecond granularity.
> Use current_time() to get the right granularity.

I had thought these were being handled as a group. I'll push this one
through the jfs tree.

Thanks,
Shaggy

> 
> Signed-off-by: Deepa Dinamani <[email protected]>
> Acked-by: Dave Kleikamp <[email protected]>
> Reviewed-by: Arnd Bergmann <[email protected]>
> ---
>  fs/jfs/ioctl.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/fs/jfs/ioctl.c b/fs/jfs/ioctl.c
> index 8653cac..b6fd1ff 100644
> --- a/fs/jfs/ioctl.c
> +++ b/fs/jfs/ioctl.c
> @@ -121,7 +121,7 @@ long jfs_ioctl(struct file *filp, unsigned int cmd, unsigned long arg)
>  
>  		jfs_set_inode_flags(inode);
>  		inode_unlock(inode);
> -		inode->i_ctime = CURRENT_TIME_SEC;
> +		inode->i_ctime = current_time(inode);
>  		mark_inode_dirty(inode);
>  setflags_out:
>  		mnt_drop_write_file(filp);
> 

------------------------------------------------------------------------------
Developer Access Program for Intel Xeon Phi Processors
Access to Intel Xeon Phi processor-based developer platforms.
With one year of Intel Parallel Studio XE.
Training and support from Colfax.
Order your platform today. http://sdm.link/xeonphi