Re: configuring transparency
Bjørn Lindeijer <b.lindeijer-qWit8jRvyhVmR6Xm/[email protected]> Fri, 16 Apr 2004 16:48:23 +0100
| Newsgroups | gmane.comp.freedesktop.xserver |
|---|---|
| Message-ID | <[email protected]> |
If the few comments in source and config file are not enough, you can probably try to reach the author directly (Jean-Christophe Hoelt - [email protected]). I think he's also on this list, but am not sure if he's following it. Regards, Bjørn koudelka-XSOnIo2nfpPtwjQa/[email protected] wrote: > On Fri, Apr 16, 2004 at 04:15:01PM +0100, Bj?rn Lindeijer wrote: > Not very clearly documented? > > Is there ANY doc? :-) I was unable to found it. > > Thank > > >>Or try the xcompmgr from here, which has been posted to this list >>earlier. It should allow crude configuration for what to do with which >>windows. Not very clearly documented though, but might work for you. >>It's also a bit more efficient because it pre-calculates a corner of the >>shadow. >> >>http://jeko.ios-software.com/ >> >>Regards, >>Bj?rn