Re: configuring transparency

I feel as a mad now... there is a config file? Where? 

I really don't now ANY parameter I can specify, to xcompmgr... where I found it?



On Fri, Apr 16, 2004 at 04:48:23PM +0100, Bj?rn Lindeijer wrote:
> If the few comments in source and config file are not enough, you can 
> probably try to reach the author directly (Jean-Christophe Hoelt - 
> [email protected]). I think he's also on this list, but am not sure if he's 
> following it.
> 
> Regards,
> Bj?rn
> 
> 
> koudelka-XSOnIo2nfpPtwjQa/[email protected] wrote:
> >On Fri, Apr 16, 2004 at 04:15:01PM +0100, Bj?rn Lindeijer wrote:
> >Not very clearly documented?
> >
> >Is there ANY doc? :-) I was unable to found it.
> >
> >Thank
> >
> >
> >>Or try the xcompmgr from here, which has been posted to this list 
> >>earlier. It should allow crude configuration for what to do with which 
> >>windows. Not very clearly documented though, but might work for you. 
> >>It's also a bit more efficient because it pre-calculates a corner of the 
> >>shadow.
> >>
> >>http://jeko.ios-software.com/
> >>
> >>Regards,
> >>Bj?rn
> 
> _______________________________________________
> xserver mailing list
> [email protected]
> http://freedesktop.org/mailman/listinfo/xserver

-- 
Michal Koudelka
koudelka-XSOnIo2nfpPtwjQa/[email protected]