DELL S3148P with OS9 - Egress-VLANID-Support?

Hello!

I'm trying to find out, if the DELL switch S3148P with OS9 (9.14.2.23)
supports dynamically setting of tagged VLAN-IDs.

Setting the untagged VLAN-ID with "Tunnel-Private-Group-Id" attribute works.
I tried setting the tagged (and untagged) VLAN-IDs with the "Egress-VLANID"
attribute, but without success.
This still can be a configuration problem on my side.

If I execute the "show vlan" command, I see the following:

ASW01# show vlan

Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C - Community, I - Isolated
       O - Openflow, Vx - Vxlan
Q: U - Untagged, T - Tagged
   x - Dot1x untagged, X - Dot1x tagged
   o - OpenFlow untagged, O - OpenFlow tagged
   G - GVRP tagged, M - Vlan-stack
   i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged

    NUM    Status    Description                     Q Ports
*   1      Active                                    U Po49(Te 1/49)
                                                     U Gi 1/48
                                                     U Gi 2/1,2/14,2/16-2/17,2/19-2/22,2/24,2/38-2/39,2/41-2/45,2/48
    1004   Active    ANS-LAN-WLMGM01                 T Po49(Te 1/49)
                                                     x Gi 2/44                          <------ HERE
    1053   Active    LAN-ZUK02                       T Po49(Te 1/49)

In this case (HERE) the untagged VLAN was correctly set via Radius.

If you take a look at the legend above, you will see:

   x - Dot1x untagged, X - Dot1x tagged

So, I suspect in general the assigning of untagged AND tagged is supported.


Because I cannot find any further information in the internet, I hope some user here
can help me...

Regards
 Sven

-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html