advcfg works but NO games will display correctly

Hi all,

Have looked through the archives and the documentation
but I cant seem to sort this problem out!

I have a standard arcade monitor (15.72 electrohome 26
inch). I run the advcfg routine, put in 5-90 / 15.72 /
50-60 then get the test pattern..it looks fine centre
it and save it.

When I test the different resolutions out they all
have a rainbow colour cast across the screen, but most
of the lower resolution screens display ok..eventually
at the higher resolutions they start to roll and
eventually go out of sync.

Save and exit.
Run a game without any menu or front end and the image
is way out of sync, roling and tearing and impossible
to get in sync of the arcade monitor.

Is there something obvious I am doing wrong..?

Thanks
Rolf

Rolf Herbert
MSN = kangarolf-/[email protected]
°ºOº°ºOº°ºOº°°ºOº°ºOº°ºOº°


	
	
		
___________________________________________________________ 
Yahoo! Messenger - NEW crystal clear PC to PC calling worldwide with voicemail http://uk.messenger.yahoo.com


-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
___
Unsubscribe at https://lists.sourceforge.net/lists/listinfo/advancemame-users