RE: Root filesystem
Robert Bielik <[email protected]>
| Newsgroups | gmane.comp.gcc.cross-compiling |
|---|---|
| Message-ID | <[email protected]> |
Thanks all, A lot of good info! I now got myself some studying to do... 😊 Regards /Robert > -----Original Message----- > From: [email protected] [mailto:crossgcc- > [email protected]] On Behalf Of Bill Randle > Sent: den 30 november 2017 16:34 > To: [email protected] > Subject: Re: Root filesystem > > On Thu, 30 Nov 2017 14:29:59 +0000 > Josh Branning <[email protected]> wrote: > > > On 30/11/17 08:13, Robert Bielik wrote: > > > Hi all, > > > > > > New to the tool! I'm planning to use this for setting up a complete > > > build toolchain for Raspberry Pi 3. This means building f.i. > > > ALSA/GStreamer/LADSPA etc. etc. and installing them in the proper > > > rootfs which will be packaged together with the toolchain. > > > > > > I suspect this is out of the scope of the ct-ng tool ? Maybe > > > someone has ideas or pointers on how to accomplish this ? > > > > > > Regards > > > /Robert > > > > > > > > > > > > > Hi, > > > > I once did something similar for the olinuxino lime A10. > > > > I compiled uboot and a kernel and used an arch linux arm rootfs. > > > > The scripts can be found as a tar.gz > > > > They are probably out of date, but can be modified and can give a > > skeleton for you to work with. > > > > http://www.publicsite.org/J05HYYY/software_downloads/olinuxinolime- > archlinux.tar.gz > > > > I'm not quite sure about the bootloader in the pi however, whether or > > not it can use uboot. The pi needs a blob to run IIRC. > > > > You may also wish to look at https://github.com/RPi-Distro/Pi-gen > > which creates the isos for raspbian from the pi foundation. > > > > Josh > > In addition to buildroot, you can also use the Yocto Project > (https://www.yoctoproject.org). There are people that have added R-Pi > "layers" for the Raspberry-Pi. One of them is this one: > https://github.com/jumpnow/meta-rpi . > > -Bill