Re: Almost successfull compiling GCJ, however..

Me Myself and I <[email protected]> writes:

> obj/gmp/fib_table.h
>
> is an empty file.
>
> ?

That is not good.  fib_table.h is a generated file.  It is built at
runtime by the gen-fib program.  Try simply removing fib_table.h, and
see if it gets rebuilt correctly.  If not, look at the commands that
make shows.  You should see it running gen-fib.  You will need to figure
out why gen-fib is not outputing anything.

Ian


>> Date: Mon, 5 Mar 2012 09:25:47 +0000
>> From: [email protected]
>> To: [email protected]
>> Subject: Re: Almost successfull compiling GCJ, however..
>> 
>> On 03/05/2012 05:10 AM, Me Myself and I wrote:
>> > 
>> > In response to the previous email to self, I have altered the prefix to be
>> > 
>> > --prefix=/home/User/
>> > 
>> > and encounter the precise same sort of error:
>> > 
>> > make;
>> > 
>> > fib2_ui.c:76:29: error: 'FIB_TABLE_LIMIT' undeclared (first use in this function)
>> > fib2_ui.c:76:29: note: each undeclared identifier is reported only once for each function it appears in
>> > make[5] *** [fib2_ui.lo] Error 1
>> > make[5] Leaving directory '/home/User/gcc-4.6.2/objdir/gmp/mpn'
>> > make[4] ***all-recursive] Error 1
>> > make[4] Leaving directory '/home/User/gcc-4.6.2/objdir/gmp'
>> > make[3] *** [all] Error 2
>> > make[3] Leaving directory '/home/User/gcc-4.6.2/objdir/gmp'
>> > make[2] *** [all-stage1-gmp] Error 2
>> > make[2] Leaving directory '/home/User/gcc-4.6.2/objdir'
>> > make[1] *** [stage1-bubble] Error 2
>> > make[1] Leaving directory '/home/User/gcc-4.6.2/objdir'
>> > make: *** [all] Error 2
>> > 
>> > Why on earth doesn't this complete without these errors?  Can I afford to ignore them
>> > and go on to make install; anyway?
>> 
>> It's hard for us to understand why you haven't looked to see
>> what the problem is.  FIB_TABLE_LIMIT should be defined in
>> obj/gmp/fib_table.h.
>> 
>> Andrew.
>