☠ Buildbot (Sourceware): gcc-autoregen - failed compile (failure) (master)
builder--- via Gcc-testresults <[email protected]>
| Newsgroups | gmane.comp.gcc.test-results |
|---|---|
| Message-ID | <[email protected]> |
A new failure has been detected on builder gcc-autoregen while building gcc.
Full details are available at:
https://builder.sourceware.org/buildbot/#/builders/269/builds/26220
Build state: failed compile (failure)
Revision: 2791799fe11f886736869e3aff093e0c14fb10b8
Worker: sw3bb1
Build Reason: (unknown)
Blamelist: Kyrylo Tkachov <[email protected]>
Steps:
- 0: worker_preparation ( success )
- 1: git checkout ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/1/logs/stdio
- 2: autoregen.py ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/2/logs/stdio
- 3: git diff ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/3/logs/stdio
- 4: mkdir objdir ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/4/logs/stdio
- 5: configure ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/5/logs/stdio
- 6: make html ( failure )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/6/logs/stdio
- warnings (27): https://builder.sourceware.org/buildbot/#/builders/269/builds/26220/steps/6/logs/warnings__27_