☺ Buildbot (Sourceware): gcc - build successful (master)
builder--- via Gcc-testresults <[email protected]>
| Newsgroups | gmane.comp.gcc.test-results |
|---|---|
| Message-ID | <[email protected]> |
A passing build has been detected on builder gcc-autoregen while building gcc.
Full details are available at:
https://builder.sourceware.org/buildbot/#/builders/269/builds/26373
Build state: build successful
Revision: 9a54dbee11c890546b0bad8e3022296f02449181
Worker: x3d1
Build Reason: (unknown)
Blamelist: Daniel Barboza <[email protected]>
Steps:
- 0: worker_preparation ( success )
- 1: git checkout ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/1/logs/stdio
- 2: autoregen.py ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/2/logs/stdio
- 3: git diff ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/3/logs/stdio
- 4: mkdir objdir ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/4/logs/stdio
- 5: configure ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/5/logs/stdio
- 6: make html ( warnings )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/6/logs/stdio
- warnings (135): https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/6/logs/warnings__135_
- 7: make regenerate-opt-urls ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/7/logs/stdio
- 8: git diff_1 ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/8/logs/stdio
- 9: rmdir objdir ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/269/builds/26373/steps/9/logs/stdio